DMG 2 T KNX

Description

2-way universal dimmer actuator MIX2
Basic module MIX2
Can be upgraded to maximum of 6 channels
For dimming dimmable LED, incandescent lamps, LV, HV halogen lamps and energy saving lamps
Also suitable for dimming of dimmable energy-saving lamps
Also suitable for controlling fans
Up to two extension modules MIX or MIX2 can be connected to one basic module
Device and KNX bus module can be swapped independently of each other
Removable KNX bus module enables devices to be changed without reprogramming
Manual set-up and use of switching actuators is possible without KNX bus module
LED switching status display for each channel
Manual operation on device (even without bus connection)
Dimming output: 400 W/VA per channel or 800 W/VA in parallel operation
If the DMB 1 T KNX 'Dimbooster' is used, the dimming output can be upgraded to 300 W/VA. Output to a maximum of 2000 W/VA by using max. 4 boosters possible
Automatic load detection (can be deactivated)
For R, L and C loads

Operating voltage KNX	Bus voltage, ≤10 mA
Operating voltage	230 V AC
Frequency	50 Hz
Stand-by consumption	0,9 W
Width	4 modules
Installation type	DIN rail
Type of connection	Screw terminals
Max. cable cross section	Solid wire: 0.5 mm² (Ø 0.8) to 4 mm² \| Stranded wire with end sleeve: 0.5 mm² to 2.5 mm²
Number of channels	2
Lamp types	Incandescent, low-voltage and high-voltage halogen and dimmable energy saving lamps and LED
Switching capacity per channel	400 W
Switching capacity in parallel operation	800 W
Switching capacity dimmable energy saving lamps per channel	80 W
Switching capacity dimmable energy saving lamps in parallel operation	140 W
Switching capacity dimmable 230 V LED per channel	60 W
Switching capacity dimmable 230 V LED in parallel operation	120 W
Switching capacity min.	5 W
Max. cable length	100 m
Ambient temperature	-5 °C … +45 °C
Type of protection	IP 20
Protection class	II according to EN 60 669