KNX switch actuator with current monitoring
Efficient current monitoring
Our new MIX switch actuators for higher lamp loads (C-loads) offer integrated current monitoring and can be easily upgraded from four to twelve channels.
Highlights of the new MIX 2 Switch Switch actuators KNX C-Last at a glance
- Precise current measurement: Four outputs for 4 C load with bistable relay allow high lamp loads. Additionally there is a current measurement (strength of current) at every output. The monitoring of the current can be used for failure monitoring of electrical devices as well as for visualisation. The current values can be used by means of a parameterized power calculation on device for extern display.
- Modular construction: The 4-channel basic device with detachable bus modules can be upgraded with max. 2 extensions without bus module. The manual operation and the use of the switch actuators is also possible without the bus module KNX. By starting the bus system the parameterized KNX bus module can be applied later.
- Flexible application range: The new MIX 2- basic devices can be combined with all upgrade devices of the actual MIX 1-series with switching, dimming, control of blinds, as well as 1 - 10 Volt control of heating and binary inputs.
Technical details for KNX switch actuator with current monitoring:
Theben switch actuators C-Last 4-12 channels MIX 2 Basic module
Theben switch actuators C-Last 4-12 channels MIX 2 Upgrade module